Thank you for your answers.
@Carla_Birch
I have not checked Vref, I will try to advise and check. But at 100% flow, it can be seen that the extruder is already pushing very much filament. I calibrated the steps for the extruder to a Creality filament in white. From the default value of M92 E93, I adjusted the step value to M92 E98.27. When calibrating the flow of the same filament, I had to change the flow to 95.24%. Now I have another filamet and when calibrating the flow I got a value of 93.02%.
I hope I didn't make a mistake during the calibration.
@GregValiant
I tried your recommended settings, leaving the line width at 0.4mm.
In the first attempt, I left everything original (including print speed), I just adjusted the two recommended parameters. The result was bad.
In the 2nd attempt, I reduced the speeds, but there were still gaps in one hole. I don't know what to do anymore.
I also attach the Cura profile from the 2nd print attempt. Can you please see if I have something wrong there? Thank you for your help.
Profil.curaprofile