AcSYS

Edit, The speed is working. So now I just need to figure out the heated chamber. I tried setting M6013 S{Build Volume Temperature} and also S{M141} in the start Gcode. but neither of these work.

Hi everyone, I have a Creatbot PEEK 300. I am working on getting it setup in Cura. Currently I have a couple problems. The heated chamber for this printer uses M6013 in the gcode. However Cura sets this to M141. Is there any way I can change this? I am using Marlin for the gcode flavor. When printing the first layer, it is running to fast. I have the print speed set to 30mm/s and first layer speed is 15mm/s. However it seems to only run with the 30mm/s speed. Looking at the gcode, it sets the speed using "G1 F900 X117.799 Y121.484 E0.02677". Looks like non printing moves use F3600 and if I scroll down further in the gcode, it seems to set it to F1800. I am not sure how these numbers correlate to mm/s, but I would guess that F1800 is 30mm/s F900 is 15mm/s. Although it definetely does not look like that is the speed the head is moving. Thank you for the help