Mightycorndog

Hi there, Thank you in advance for any help you may provide. I've been trying to print a version of a game called 'secret hitler' for my brother. I'm using a creality CR-10 3D printer (I realize it isn't an ultimaker but this is the best forum I know of for 3D printing advice). I am trying to print a game tile but for some reason the details come out completely ruined. I've done a lot of research and the most obvious cause for this is over-extrusion but no matter how I adjust the flow and print temp it doesn't fix or even slightly change the outcome of the print. Another possible cause is that perhaps my printer is making the layers too thin and is subsequently squishing higher layers but I honestly don't know and even if that were the case I don't know how to fix it. The first layer is perfect then subsequent layers look squished. Any advice would be greatly appreciated! Attached are photos of the design as it's supposed to be and how it turns out when I try to print. Creality CR-10 Nozzle Temperature: 200C Bed Temperature: 50C Layer height selected on slicer: 0.2mm Thank you again for any help!