ITJake

GregValiant, thanks for the info. I was thinking that's what would have to be done but wasn't sure of the code to insert. I was searching last night for the codes to use and just couldn't find them since there are so many sites that have them but either don't explain what the code is or say it may not work in the software your printer is using. Thanks again.

Is there any way of telling Cura that I want layers 1 through twenty at 130% extrusion? Layer 0 must be at 100% then switched to 130% @ layer 1 and print at 130% until layer 20, then change speed to 80% @ 100% flow rate until layer 30 where it can start running at it's normal speed of 100% @ 100% flow rate. Thanks in advance.