Jump to content
Ultimaker Community of 3D Printing Experts

heymoa

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. I have a model which doesnt need supports due to overhang but if it was printed it would topple over due to the offset mass. A raft will not hold the cantilever so I wonder if there is a way in Cura to combat this. Thoughts are to change the support angle until supports are generated in a way that it will stop it falling over or model supports manually. Cura almosts needs an apply gravity option so when you drop the model on the plate it warns you about it falling over.
×
×
  • Create New...