IDo3D

Thanks, I've already installed 4.6.2, I didn't have many settings to change anyways. I'm just learning everything now. But yeah, with 4.6.2, all the little bumps are gone with the exception of the layer seam. I stopped the print early b/c of that. Any idea how to get rid of that? The interesting thing is that I used both of creality's versions, 1.2.3 and 4.2.1, and 1.2.3 had only a handful of minor bumps and no seam. It had some uneven layers lower on the hull along with a few more bumps around the cabin and a few other minor defects. 4.2.1 had a few more bumps all over it, and also some slightly uneven layers on the hull. When I get some time, maybe I'll go back and try your values with 4.7.1, in the meantime, I'd like to get the correct settings for 4.6.2 to remove the seam and just be happy with that. Attached are partial hulls showing 4.6.2 vs 4.7.1.

I just got an Ender 5 Pro and tried the Benchy with Cura 4.7.1 and it suffers badly from bumps, particularly along the seam, and in random places on the hull, all below the decking. Everything above the decking is pretty clean. Doesn't seem quite as bad as in OPs pic though. I have the stock 32 bit silent board, v4.2.2 with TMC2208 drivers (some 4.2.2 boards, and I think 4.2.7 may also, use HR4988 drivers). I just flashed the TH3D unified firmware and tried again and have the same results. Where can I get Cura 4.6.2?