Jump to content

gerrul3r

New member
  • Posts

    1
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other 3D printer

gerrul3r's Achievements

0

Reputation

  1. Hi out there ! This topic has been a while but I want to share my experience: I was faced to similar problems, my outer wall didn´`'t connect with the inner wall. I was able to fix this issue a bit more, not perfectly, but acceptable: Try this: - increase the infill overlap to at least 30% - enable ironing to smoothen and connect the outer wall to inner parts: Since I use this configuration, I had good results by small expenses of increased time and material (around 5-10% ?). Further settings can be considered: - printing temperature increase by a few degrees - decreased print speed - increase your E-steps for extruding, just a few percent (0,5-1%) I'm not a professional, but experimenting with above values @213°C print,63°C bed, PLA on glass-bed (no-adhesion additive) had improved my printing quality a lot.
×
×
  • Create New...