mattia_poli

I can provide more information: - Ultimaker 2+ - Ultimaker TPU95A - I print to the suggested temperature of 235°C and it was worse compare to when I crank to 241°C - Speed reduced of 50% respect the Cura preset suggestion - Fan speed 10% - No retraction

Dear users, I would like to know if someone has experience with TPU95A 3D printing. Currently I get my job done but I think there is still rooms for improvement. I'm printing this kind of cylinder (height: 10 mm, look at the picture ). I tried different printer parameters, mostly towards to slower process and increase temperatures. Can you share some advise for fixing some of the bad prints layers (they looks mostly in the upper part)?