Jump to content
Ultimaker Community of 3D Printing Experts


New member
  • Content Count

  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. I have a similar problem. I use a brandnew ultimaker S3 an the delivered PVA Material. Somtimes it is printing fine. But a print in few minutes later the unchanged material PVA brakes mainly in the tube. I think this type of Ultimaker material is not the best. How ever it is not weth it is try. But it contans some points of weak material where it brakes. It is a mess. on the other hand it prints sometimes for houres.
  • Create New...