paradoxical3

Hello, I have an Ultimaker S5 which, despite the constant bugs and beta nature of the software (wifi always disconnects, camera craps out after 30min, it forgets it's connected to the Ultimaker Digital Factory, print to cloud rarely works, etc, etc, etc) is quite a versatile printer and does have good print quality. My hardware setup: Ultimaker S5 with Air Filter CC core with Ruby for the main material, BB .04 core for the suppport eSun heated drybox @ 55c NylonX, Zytel, NylonG, and Aquasys `120 all dried at 70C for 12 hours directly before print However, I have run into something that has me completely stumped. I recently got a spool of Aquasys 120 to print as a dissolvable support material with Nylon. I downloaded the Ultimaker Aquasys 120 profile and loaded it into cura without modifying it and tried a print with NylonX. Wow! It came out amazing. Perfect adhesion, no stringing, dissolved way faster than PVA, etc. I was totally sold. That was the last time my printer ever wanted to feed it properly. Every time I use it now, it just grinds. It grinds when loading, grinds when printing, and eventually under-extrudes to the point where the print stops. Normally, when under-extrusion or grinding issues happen it is a byproduct of incorrect nozzle temperature (too low), wet filament, a clog, retraction settings, a dirty or worn gear in the feeder, etc. So naturally, I went about troubleshooting: 1. Dried all filament 2. Did soft and hard pull cleans (filament ends came out clean and good) 3. Cleaned the feeder 4. Tried at higher and lower nozzle temps No change - at this point, I tried PVA, Breakaway, and PLA through the BB core and feeder and they worked great with no grinding. But Aquasys was a no-go. Given those results, I started to think I had a defective feeder or print head. So I mixed and matched, swapping bowden tubes, feeders, and print core locations to isolate them individually. Still no go, Aquasys ground no matter which feeder, print head, or bowden tub was used. At this point, I am completely confused. What possible variable is left, and is anyone else having issues with Aquasys?