Kohlery

I had a similar issue. I tried to import my profiles from (i think)4.3 to 4.7 and noticed that even with the message that it worked, the actual profile was nowhere to be found. And this is my solution 1. Set material type to generic PLA and the nozzle size to 0.6mm. With these settings were my profiles shown. If you can't see yours try all the nozzle sizes and even then might my work around still work. 2. To have all my profiles shown with 0.4mm nozzle the following steps are required. In the folder of your profiles (i would strongly recomend making a copy of all profiles at that point in cases something goes south) rename the profiles from .curaprofile to .zip. 3. unzip the two files in the new zip document. edit both via editor and change "quality_type = draft" "setting_version = 6" to "quality_type = standard" "setting_version = 15" or "quality_type = super" "setting_version = 15" (for super fine printsettings) 4. zip them together again and change the .zip back to .curaprofile 5. import

I had a similar issue. I tried to import my profiles from (i think)4.3 to 4.7 and noticed that even with the message that it worked, the actual profile was nowhere to be found. And this is my solution 1. Set material type to generic PLA and the nozzle size to 0.6mm