Hi Everyone,
I'm fairly new to 3D printing and I wanted to see if I can get some help with my prints! I've been trying to print out some cookie cutters with PLA and I get keep getting these blobs/zits up and down my print. I've tried changing the temperature and the retraction settings and this is the best I can get my print with my cura settings below. Does anyone have any suggestions?
Cura 4.8 Settings
layer height - 0.4mm
hot end temp - 190
print speed - 30
travel speed - 30
retraction dist - 3mm
retraction speed - 50mm/s