So I downloaded 4.7.x (what was available last week) and installed it on my Win7 machine. Install went fine. Setup went fine. Tried to load in a model file and once I clicked the open folder in the upper left Cura crashed out. I didn't have time to mess with it so I kept using the Creality slicer for my CR-10. Well I have some time this week. I saw a similar post about Cura not working on a win7 machine so I tried running it in compatibility mode. All of them. Same result. So I went on the website to see if I could go back a version or two and saw you released 4.8. Figured I'd give