UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Thank you very much for your suggestion! I will try it out!
Altough it doesn't affect the prints, I'll still try to find out why it adds a duplicate "G92 E0"
Thank you for the reply and suggestion! I will try the plugin you suggested.
Here is the start of the G-code:
Initially there was 3 "G92 E0"(now 2) and I removed that final line from my "Start G-Code" (in printer settings), don't know where that comes from either... here the 3 "mysteriously" added lines:
"G92 E0
G92 E0
G1 F1200 E-3.5"
;FLAVOR:Marlin
;TIME:1338
;Filament used: 0.903344m
;Layer height: 0.2
;MINX:93.693
;MINY:94.154
;MINZ:0.2
;MAXX:126.307
;MAXY:130.208
;MAXZ:18.4
;LINEARADVANCEPROCESSED
;ZOFFSETPROCESSED
;Generated with Cura_SteamEngine 4.8.0
M140 S70
M105
M190 S70
M104 S235
M105
M109 S235
M82 ;absolute extrusion mode
G28 ; Home all axis
G0 Z15 F3000 ; Move up 15mm at 3000mm/min
G92 E0 ; Reset extruder length to zero
G0 X0 Y0 F3000 ; go to edge of print area
G0 Z0.14 F3000 ; Go to Start Z position
G1 Y60 E9 F1000 ; intro line 1
G1 Y150 E30 F1000 ; intro line 2
G92 E0
G92 E0
G1 F1200 E-3.5
;LAYER_COUNT:92
M900 K0.100000 T0 ;added by LinearAdvanceSettingPlugin
;LAYER:0
M107
G0 F9000 X97.869 Y98.209 Z0.3 ;adjusted by z offset
G92 Z0.2 ;consider this the original z before offset
;TYPE:SKIRT
[---]
Hi!
The same thing is happening to me and I can't figure how to change the options to "2 Extruders" (can't change it in printer profile, there is only "1")..
Is there another way around this?
This is new, it was working fine until yesterday..