Ray_McRay

Z steps calibration could be another probable solution

- If the print always fails at exactly the same height, check your Z Axis. - This seems like a very thin and high part, does the wall start to wobble at some point maybe? - How is general adhesion between layers? Try to increase line width by 10-20%, that way the filament gets "squished" and sticks better to itself.

Yes! This was it! Thank you. This option really should show when you type in "height" in the search bar... Edit: It does. Facepalm.

See Screenshot. Is there something like "automatic Layer height correction"? How can I turn it off? P.S.: I am aware that a 0,16 mm is not necessary for this specific part. This is a Test part.

Disclaimer: I am aware that you're not supposed to print Benchy with support. Just trying to learn/understand the program and experimenting with settings. Thanks in advance!

Sorry if this is a stupid question, I'm new to Cura