Jerrymc3

So will your copy slice and can you send it to me or is there a way to fix mine? Jerry

Sorry its taken me so long to get back to this but I've been very busy. Here is the stl file created in blender. Dual_Gauge_Gear_13.stl

I tried that saving as both 3MF and stl format but when I slice them with Cura I still get 0g. Jerry

I made this gear for dual servos in Blender 3.5. When I open it in Cura it doesn't show any errors but when I slice it , it shows 0g. Maybe it needs to be made solid but I don't know how.

What does the green at the top of the model indicate and how do I tell whether the area is infilled or solid?

I couldn't find this in Cura. However, I went into Blender and made a curved block to fit the part and inserted it in Cura. I hope this does the same thing. Jerry

I'm using Cura 4.7.1 and I couldn't find a couple of the settings gr5 used. I used your fillet but that wasn't where the break was, it was at the top. I think I need to make that whole end where the curve is completely solid but I'm still not understanding how to do that. Jerry

I'm making parts for a B737 Throttle Quadrant. One of them broke because it needs to be solid in that area rather than infilled. Is there a way to make a certain area of a part solid?