UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
The funny thing is , I accidentally got it working 1 week ago. I don't know how. The problem was, Only 1 extruder was operating. Had to re-config. hence the present delima. Thanks for helping or just listening.
Yes I have checked and double checked connections. It came idiot proof so I couldn't mix up the wires. I mixed the rails and had to rebuild but that's on me. I have 4 extruders which are all working fine along with heating of the filaments. This is a head scratcher. |Still working on it.
Z9-main.zip
Don't want to flash the firmware. I am not sure how to correct my x,y and z axises from trying to home in the opposite directions. Any ideas of how to correct this?
Thanks or your response. better than I got from Cura. They just bot me a standard response that I should contact the mfg.
I do have all the required updated cfg, hex and .frm to setup this machine. I did figure out how to add this machine to cura's machine choices. I am now looking to use github upload tool to load new settings through arduino. wish me luck.