Hi everyone,
I have been using cura for a while now, this is my first post. I can manage most prints and they are flawless with cura.
However, I have had an issue where I am wanting to use an stl which is approximately around 750mb. However, when I go to slice, it says 'processing; and then 'slicing'.
The issue is that the slicing bar doesn't move even after 6 or 7 hours there is no progress.
The computer is no slouch, its an i7-6700k with 16GB ram and an Nvidia 1070 card running windows 10 and using cura 4.8