Jump to content

TAVARES

Member
  • Posts

    8
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Ultimaker S3

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

TAVARES's Achievements

0

Reputation

  1. Here is a picture of what occurs. It is odd as this ONLY happens when I use the second extruder for Support. All the belts are tight no missing Tooth/Teeth. I completed X/Y and a switch calibration but nothing positive. Could the stepper motor be bad?
  2. Nope. I will check it again. But if there was a missing tooth or slips it would happen with both Extruders. Or, did I miss something?
  3. I'm having a bit of trouble getting the Ulti 3 Extended to find and use the Lift Switch properly. The parts had warped, the print bed had been knocked about 1 inch to the right, and the print was offset on the X and Y axis part way through. I performed a full maintenance cycle, including XY offset calibration and a lift switch calibration, but I'm still having issues. When I set a print to go the print head moves to the lift switch to change print cores, and it works a few times but but seems to miss on the Y axis by about an inch after, even after all of the maintenance and calibration. It prints OK with just one extruder but really need this working again. Does anyone know why it might be doing this, and what I can do to fix it? Thanks in advance!
  4. OK. So that gets me to 160 X 210 X 36.6 mm But how could I get to 215 x 215 x 200mm, see below.
  5. That great but I really need it to print the 215 x 215 x 200mm as well. In this example, I removed the blob and the skirt but I still can get it to 160 X 210 X 37. I love the advice, I Just need more.
  6. Hi Everyone: I removed the Blob and the Support and Adhesion but the Grayed out areas on the bed are not allowing me to print the sizes that were in spec. My customer really need this, and I would like to have an answer sooner than later.
  7. We had purchased the Ultra Maker Cura 3 but have encountered an issue. The Specs read the Build volume is 215 x 215 x 200 mm https://shop3d.ca/products/ultimaker-3 But when we attempt to print something at 159 mm X 205.9 mm X 38.8 mm we cannot lay it flat. Version 4.71. The customer needs/want it to be printed FLAT. Can you provide an answer? Thank you.
×
×
  • Create New...