Hey everyone, trying to figure out an issue with my Ender 3 Pro using Cura's pause at height plugin. For some reason, it seems to skip the layer before the pause, and I'm not sure exactly why. For these settings, I watched the part be printed, and it printed fully at the 1.8 layer, paused, then resumed at 2.2, essentially skipping the layer at Z=2. I've attached my plugin settings as well as the section of the GCode where I believe the issue is, but I don't know enough about it to understand what the issue is. Using the latest TH3D firmware for the 4.2.7 silent board. Any help is appreciated!