remyhx

1.5 years old, original box with: - two extra glass plates - extra small printcore AA0.25 - 3x PVA 375 - 3x tough PLA wit - 2x PETG zwart - 1x PETG wit reason to sell: my project needed a resin printer. Of course this one is just ok. location: The Netherlands

GregValiant and gr5 many thx for the answers! As proposed by gr5 I just changed support placement, put ventilation on 100% and lowered the bed temp to 70 degrees. Within 2 hours the calibration cube should be finished with these settings (based on the first one, but with these changes). Thinking of heat: I use a cover to maintain heat and reduce particulate matter: Maybe that wasn't a wise decision, although I thought it would also benefit because of stability in temperature. And gr5: you mentioned the deformation of the lid, it was also deformed in the same way: Up is the lid, little bit warping(?) at the upper left and the same smaller aspect of the cube. Will post the result of the next print in a couple of hours 🙂 cal.3mf

Ok, sorry! Here it is :) project.3mf

Hi, While printing a cube (Petg Ultimaker with my S3) the first 3 a 4 mm’s differ from the last ones. (Left model). Somekind of step is made, although it’s not designed. Could this be due to the printing of the lid at the right (comparable height), the model looks almost like modified by heat. I am a beginner.

At the end the machine was taken back and i got a new one... All problems are over now!

Hi, i’m new at 3D printing; this is my third print 🙈. i noticed some strange pits and extensions, while printing in fine 0,1mm with some adjustments to speed (max 35) acceleration (max 2000), print jerk (25) and outer before inner walls (these changes were made because of some suggestions in a YT movie, to print more precise) printer S3, tough pla and pva. And maybe its just normal, because of the circumstances (next to openings which are supported by pva)

I guess it is then. But it can’t harm to discuss it i guess... The printer prints perfectly, it only gives me a bad feeling (like buying a scratched car). Thx for the reply!

Thanks for the reply! I will discuss it with him! yes its the correct port, strange.. And the firmware update issue is solved now for me :))

Hi, yesterday i received my new S3, but encountered some strange problems/“features” haha. I already sent Ultimaker a messenger app, but didn’t received a reply so far.. firstly the nfc spool encounters a problem. The printer doesn’t recognize the spools, i have to register them as third party spools. But can print at least.. Of course i checked the wires. secondly: even after updating firmware, the update function constantly remembers to update. Is that a known issue? (Not as a printtask but as an option in the menu) and thirdly: when i startup the machine, sometimes some digital snow (matrix movie like haha) appears at the screen. Is this normal? Its gone after startup. maybe an Ultimaker employee can help 😃 but! Most important: it prints! :)