ger21

I'm trying to get my X-Pro working with Cura 4.8, and have run into the same issue. I've used it quite a bit using the right extruder with the files that Qidi sent me. But when you try to use the left extruder, you run into the problem of the right extruder heating up. So my "solution" was to setup 3 separate printers, , for Left, Right, and Dual. I'm currently working on some definition files to make setting them up easier. To make the left extruder active, I just add T1 to the Start G-code. Without doing this, I noticed the right extruder trying to retract the filament after the prime pass. The T1 fixed that. To fix the issue with the right extruder heating up, I've been editing the g-code and adding T1 to the M104 S### line I was playing around while typing this, and just came across a workaround using Search and Replace in the post processing plugin. My startup code uses M104 T1 S### You want to replace M104 S###, so you can search for "M104 S" and replace with "M104 T1 S" and it will add the T1 without messing with any of the other M104's. Now back to getting 3 versions of definition files working...