So, I am turning to the forums for help. I have a UM3, normally prints flawlessly-- but after a print today it decided that it no longer wanted to autolevel. This happens sometimes so I cleaned the nozzles, cleaned the bed-- tried again. Same issue. Okay! Off to the internet.
So I set my bed to 14mm. Nope. That didn't work.
I manually level the bed. Nope. That failed as well.
I calibrate the lever switch. Still nada.
I change PrintCores (both the AA and the BB). Nope.
Okay, so let's watch what it is doing. PrintCore 2 isn't touching the bed. Well that's odd. Fiddle some more. PrintCore 2 touches the bed as does PrintCore 1. Yay its-- work... it isn't working, it kicks back and says it cannot complete the autoleveling. Check my nozzles and bed.
So where I am. I have been poking at this for 4 hours now.
I am running current firmware for the UM3. I am open to anything.