UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
As I wrote, I already did this.
Since the latest version of cura, there ar no limitations by default.
I Also tried to enter 600mm/s.
But travelspeeds over 300mm/s are not accepted.
cura 4.8.0
Profile Voron2 350
Travel speed setting > 300mm/s is marked red and slicing is not possible
Allready checked the the printer settings with the extension from the markedplace.
max-X/Y = 2997924580mm/s
Printspeed > 200mm/s creaes also a warning.
How can I change this limit ?