UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Hi there,
Anyone could tell me where to find all firmware releases? The links found in the forum are not working anymore, I would like to try this approach as solution to the problem described above...
Before the printer starts the calibration and rising the bed, an error shows up and the print job is cancelled
This error appears as well when going to:
System > Maintenance > Diagnostics > Bed level sensor
I have tried to replace it for a new sensor but still the same issue
Fmwr vs: 5.2.1620200331
cap_hUMmy_1970-01-01_00.21.20_X180.0Y155.0_sensor_reset.log