Atreyan

As requested I attached the two gcode files. The SD card is not the prob... I used two different ones and the print with the file from Cura 4.9.1 works also on both of them. Cura_4.9.1.gcode Cura_4.10.0.gcode

ENDER-5 Pro, Windows 10, and64 Hi! I updated the CURA 4.9.1 to the new 4.10.0 version. Since then the all gcode files produced with this new version do not print. The BLT Touch levels the bed with the 9 points and after the last point the head stays at this place and the precentage of the print run up to 100% without any error or message OR printing!!! I tried to reinstall the old version 4.9.1 but the problem stays. On a second computer I used an older version of CURA 4.8 and the print is done as it should. How can I fix the problem?