Greg, good news, it worked! Mostly all smiles from me. Slicing in Cura, printing through mattercontrol. I found a purge code to throw in as well and it is all working great. Can't thank you enough for helping me out. I've attached a few pictures or what I was able to do last night. First benchy print in blue was completed (first one), just stringy. I upped retraction to 4mm and also dried the white filament and tried it again. The white is the result. Much cleaner and it looked pretty darn good. There is still a little bit of slight blobbing on the side of boat. Any suggestions on how to tighten that up? Is that a flow or e-steps overextrusion issue?
One other question. When the printer is not printing but travels on the X axis, there is a clunking noise that the motors/belt or something is making as it travels to the next point for printing. When it travels and reaches the end is when i hear the noise. Otherwise the printer is silent. I slowed down the travel speed from 120 to 80 which seemed to help some, but is there another setting that I should look at in Cura to help with that? I have a video of it but I can't upload it here. Thank you again for taking a look at this for me.