Hovidjian

@gr5 - I have creatbot f430, used be great but recently it started doing this. I have cleaned the all the axis. X and Y feels little sticky though. Part came out worse without Z hop. I have it at 0.2 mm all the time I had some dust issues last week in the room of the printer, so I'm guessing the bearings need to be cleaned. Tough job though.

I am having problems with the walls. If I do cube on vase mode though, comes very clean. I think it has to do with layer change. Tried different materials and same. Calibrated my steps, cleaned and regressed the rails and rods. Flow and retraction calibration. Same results with no retraction. Any suggestions please.