ntomkin

I'm going to be a little less forgiving to this situation than the trend here. Not all of us have standard printers. Given that this is a maker community, a lot of people make their printers, and spend hours and hours getting to a good configuration with Cura. Randomly wiping out profiles is comically bad design. I have a backup, so I'm lucky, but I don't think the software should bank on people exporting their profiles for each and every change. I think they meant to have a prompt that says "You have an old version of a Cura profile, time to update!" but instead they just delete them all and claim they are "corrupt." The most recent update was pretty naggy, and claimed a lot of "security" updates were necessary, or something to that effect - and yet, they didn't consider that this would be an issue? Can I get a job here? I would love to ship software where I didn't have to worry about old profiles...