Hi,
I'm currently having a related issue to this topic. I use a Creality CR-10s Pro V2 (incl. BL touch system)
I changed my nozzle to a steel plated one and apparently it had generated new issue with the bed adhesion. It wasn't the case before I changed it.
After I changed to nozzle, which seem to be exactly the same dimension as the original, I've done again the bed leveling using the tool to make a gap of 0.2 mm between the nozzle and the bed. After that my prints were not adhering anymore.
So I was trying to play whith the Z Offset to squish it to the plate a bit more. Originally it was set to -1.5 already and I was able to push it to -0.4 mm. I tried it gradually and I could see the result a bit improving each time but not sufficient and I could not increase more. The value is in red in Cura
Other param:
Initial Layer = 0.3 mm (i'm still surprised that, having an initial layer to 0.3, it still didn't grip the bed
Filam: PLA
Auto-Leveling of the printer is set to OFF
I have two questions:
1) Is there a possibility that the BL touch is causing an issue
2) Is there a possibility to push the Z offset more?
Best regards
Cura_Settings.3mf