gjacob3412

will this also work with the 3Pro? reading thus far does not mention that.

No, This is the simple LCD, non touch screen. I may have not followed good ‘IT’ troubleshooting procedures. I altered to many things at one time.. I went back after the fact and tried the print again. Even so far as to ensure the pause at height command was entered. Also, sent the print via OctoPrint. While i could not click to resume On the Ender, (Ender Jog Wheel) it did indeed pause when the resume was selected on OctoPrint. It was late enough that I didn’t have time to spin my compiled firmware back into the mix - something for tonight or this weekend. In the past, I have not needed to compile my own firmware. So that was something new for me to work with. I’ll likely install the version. I compiled and repeat the testing process.

Having some issue with the PauseAtHeight.py in that, after slicing, printing either via OctoPrint or TF Card, the Ender 3Pro fails to pause and completes the print. What has been tried: Versions of CURA: 4.8 4.5 3.6 (per YouTube video on topic. Ender 3Pro Board: 32b - 4.2.2 Firmware Version: Marlin-bugfix-2.0. (compiled) I am curious if there is anything else I could attempt. I have reviewed the gCode, and the code is there. I would think that rolling back the firmware and bypassing the OctoPrint it should have paused during the print.