Jump to content

nru

Member
  • Posts

    2
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Ultimaker S5

nru's Achievements

0

Reputation

  1. Now that is strange.. While it seemed frozen on a logo screen, I connected to it via Ethernet from Cura and successfully sent it a print job. Now it prints it like nothing happened, while the screen remains frozen. So, I suppose I have some time until it runs out of filament 🙂 Unless I somehow manage to cheatingly change it without the screen By the way, Cura reports it having firmware 6.1.1. I don't know the hardware version, but it's the old one, with robots on sides.
  2. Hello. I have exactly the same picture after updating. Unfortunatelly, I didn't look at the version, just reflexively clicked yes on a popup that asked if I want to update after boot-up. Twice it was rebooting and doing something with a prompt not to turn it off, so I didn't. After that once again it rebooted to a Ultimaker logo and nothing. After some 30 minutes I rebooted it manually (power off-on) - same thing. By the way, the flash drive that was in it during the process, has nothing new from it. Please don't tell me I have to package it and send somewhere...
×
×
  • Create New...