jjstohr13

Awesome, thank you.

That worked perfectly. awesome to get this kind of advice!

Thank you for the advice. I wasn't sure why it was waiting, so I will lower that and see what happens. I tried the pause at height but didn't know how to set it correctly. Any advice on that?

I am able to use the filament change on Cura 4.8.0, but the extruder leaves a blob of material in the printed object where it stops before going to the home position. Is there a way to tell it to stop outside of the print surface. Or is the 30mm initial retract not working or is it not enough?