Jump to content

JRANGER

Member
 View Profile  See their activity

  • Posts

    4

  • Joined

  • Last visited

 Content Type 

Posts posted by JRANGER

    Arc Welder Anti Stutter plugin

    in UltiMaker Cura

    Posted

    HAHA, finally ran into an issue with it. I tried it on my stock (Other Then HotEnd) Tevo Tornado Gold Edition which has Marlin 2.05 something on it...Didnt like it, probably doesnt have ARCs enabled. So ill have to dig into that, its been good stock so ive been trying not to change the firmware on it 

    Arc Welder Anti Stutter plugin

    in UltiMaker Cura

    Posted

    What about Reported error: G2/G3 bad parameters. I don't see any G2 codes being sent but a lot of G1 codes in my OctoPrint. I have not installed ARC on my Octo but have in CURA. 

    53 minutes ago, FormerLurker said:

    This software is free, was made by people working in their free time, and the source code is open and available to anyone who wants to take a look and help improve it, so please keep that in mind.

    Second, your problem is almost certainly due to arcs being disabled in your firmware.  I'm guessing you upgraded your printer with a bed leveler, and flashed new firmware for that.  I see lots of these firmware forks, and most of them have arcs disabled for creality printers due to limited program space.

    It's very easy to check to see if arcs are enabled within your printer's firmware by sending the following command to your printer (easiest way is with the OctoPrint terminal) and see how it responds:

    G2

    If it says 'unknown command' or something similar to that, arcs are disabled and you cannot print any gcode that contains arc commands.  If it says, "Invalid Parameters", arcs are enabled and the fault is likely with ArcWelder itslef.

     

    Arc Welder Anti Stutter plugin

    in UltiMaker Cura

    Posted · Edited by JRANGER

    I should probably also mention that I am printing with a .08 tip in point .06 Resolution so im not sure i would notice a significant difference in print. The MKS GenL board hasnt given me much problems but i had noticed before the switch over i was getting some real random movement issues so i said why not try this. 

    Arc Welder Anti Stutter plugin

    in UltiMaker Cura

    Posted

    that video is what brought me. Im using it currently on my Tevo Nereus but its also has non stock board with Marlin 2.x installed. I was using it without the G90 but noticed it the other day. Seems to work pretty decently so far with my setup but i do only get a small amount of compression however im using some pretty large files at the moment

×
×
  • Create New...