UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Thanks for the reply. I used the support blocker on that entire area and the support still shows up.
Do you think that's just a display issue in the software?
There are some areas that do need support so I can't turn it off.
I want to print a box that has an angled slot to hold a card. Cura is placing support in the slot. And also a disconnected blob that doesn't touch anything.
I haven't seen this before.
Quacks_SmallTray.stl