Jump to content
Ultimaker Community of 3D Printing Experts


  • Content Count

  • Joined

  • Last visited

Community Reputation

1 Neutral
  1. Thank you very much for helping me Everyone ,I just raised Grade 7 So I brought the motherboard to an expert In Thailand to check it He said there was a problem in some of my vcc in arduino because I just bought a second hand extension week ago So I asked to return my um2+ to the shop Thank you very much.
  2. it was uploading for 10 minutes but the rx on bord led didn't blink
  3. I'm confused because there are 2 icsp
  4. my main bord show yellow led did it missing boot loader
  5. while I update my ultimaker 2+ firmware the light when out and when i open it again the screen and led was not open when i connect the usb to my computer the computer was detect the usb but cula didn't so i can't re-install my firmware and my ultimaker is still bug sorry for my English i was thai
  • Create New...