Jump to content
Ultimaker Community of 3D Printing Experts

spaceman30

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. I have never run into this problem before. Perhaps it's a bug or just a glitch that requires restarting Cura, but I sliced a file as I normally do and during printing I noticed that my printer was attempting to print mid-air in the middle of one of my tree supports. When I looked at my sliced file I noticed that Cura had created multiple floating islands in the tree support. Has anyone else encountered this? I have attached an image of the sliced file where two of the floating islands can be seen and my gcode in case anyone is interested. beskar_mudhorn_pauldron.gcode
×
×
  • Create New...