Jump to content
Ultimaker Community of 3D Printing Experts

rhammond

Member
  • Content Count

    7
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. I will get on it, but may take a couple of days. Thanks for you help!
  2. All of my previous stl export files with pockets that have already been printed by Cura no longer show any pockets.
  3. Nothing is checked under mesh fixes Thanks
  4. Not sure where to find this?
  5. I should add to the above post, The model created in FreeCad shows the pocket. When exported to Cura, the square box shows with no pocket. This has been working fine. To test I can draw a simple box, extrude the box a few mm, then draw a smaller square on the larger box and pocket that square. Simple! I export it to Cura and the pocket does not show. Just shows the 4mm box?
  6. Just startd happening, Cura will no longer slice a pocket. The STL Files exported from FreeCad to Cura have been working fine so perhaps a setting was changed? Thanks
×
×
  • Create New...