drtiger

hi , Ursusomg, what happened to your main board , you try any mod , let us know , maybe someone is doing the same mistake ( in that case me ..) You can use another mainboard and use klipper to control it . best regards

hi, see at silhouette alta configuration on Cura , all settings are there , they are twins colido and silhouette alta .

hello, i recently acquired one (silhouette-alta 😉 and i was intrigued that, despite being closed, (great for abs ) it didn't have a heated table or fan....(required for PETG) so i decided to implement it. I'm at a stage where I make my prints in ABS (no warp) and PETG without any problems, but the table still looks like a homemade one... I'm not good with modeling. So I decided to show what I've accomplished and take advantage of the community's experience to move forward wi basically i used a w1209 ( thermistor ) with an 8 cm heated silicone base ( the one i found round ) ideally 12 cm or a 9 / 10 cm square ... I put a 3mm mirror on top and that 's it . I used a monoprice mini delta table border (mpmd) to make the frame. I hope you encourage your friends to carry out the project and point out flaws and possible improvements in the project. Yes it takes time to heat up...but it doesn't catch fire...I've been printing at 60 -70 degrees without problems (the sensor may be reading less...) and plan to put a PEI sheet on the mirror soon I've been using the blue tape so far with no problems

hello, i recently acquired one (silhouette-alta 😉 and i was intrigued that, despite being closed, (great for abs ) it didn't have a heated table or fan....(required for PETG) so i decided to implement it. I'm at a stage where I make my prints in ABS (no warp) and PETG without any problems, but the table still looks like a homemade one... I'm not good with modeling. So I decided to show what I've accomplished and take advantage of the community's experience to move forward wi basically i used a w1209 ( thermistor ) with an 8 cm heated silicone base ( the one i found round ) ideally 12 cm or a 9 / 10 cm square ... I put a 3mm mirror on top and that 's it . I used a monoprice mini delta table border (mpmd) to make the frame. I hope you encourage your friends to carry out the project and point out flaws and possible improvements in the project. Yes it takes time to heat up...but it doesn't catch fire...I've been printing at 60 -70 degrees without problems (the sensor may be reading less...) and plan to put a PEI sheet on the mirror soon I've been using the blue ribbon so far with no problems th improvements and suggestions. Basically