Jump to content
Ultimaker Community of 3D Printing Experts

EdwardFletcherMoorland

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

1 Neutral

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Managed to fix the issue, We found one of the axis was out by about 4mm. Followed a guide on how to fix and we are now up and running!
  2. I have tried printing an object yesterday and once finished I noticed it wasn't straight. I ran the XY calibration this morning and they are both in line. But it still prints on an angle. I have checked the design software and the print should have been straight. Is the something that I have missed/can try?
×
×
  • Create New...