UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
sure it didnt help.
I soldered the red and white wire in the middle wrong. Later I changed them back. Did not help. As a result, I checked the main connector, it was not plugged in, I fixed that too and the printer boots up successfully 😀
And in the middle of this "head" thing, the red and then the white wire fell off and because of this an error appears i think. I will solder them.
ult 3
Hello, do you have a board connect schema (the picture below is just an example) for all connectors to the Ultimaker 2+?
I think that my 3d printer clearly has some of the wires connected incorrectly. Thank you.