Jump to content
Ultimaker Community of 3D Printing Experts

Ratalon

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. TLDR; With any setting less than 100% CURA modifies the layers under some letters and generates holes for some reason. Small holes and lettering added to the underside of where the lettering is actually located. 0-90% infill causes this Same layer with 100% Loaded a few different profiles, they all do the same thing. CURA 4.8 Other than splicing in the 100% infill gcode into the lower % gcode to make it "right" any ideas? STL attached and located Do Not Dumb by welchomatic - Thingiverse DoNotDumb.stl
×
×
  • Create New...