Greetings!
Recently set up a new printer and had a tough time getting the Z-offset perfect. I was using a BL touch. I was thinking if it does not already exist, how would I go about creating in Cura say 9 squares (3x3) all just a single layer thick, each one would print separately, but set each z height +0.5mm the previous. Then you'd let it print and based on the best square you could adjust your z offset.
My problem right now is I am getting very nice prints, but I can tell by my brim the fist layer is thicker than it should be.
So, has anyone come across such an STL or Gcode, or how would I go about creating one? I can create the STL in Fusion say with a 0.2mm height. But how can I sett a different z height per square in Cura.
Thanks
Max