Jump to content

ascannel

Member
  • Posts

    4
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Ultimaker 3 (Ext)

ascannel's Achievements

0

Reputation

  1. Thank you for your response. sorry I misspoke about the issue, I was able to unload the filament but the material near the nozzle is preventing me from properly squeezing the levers to slide out the PrintCore. I am working now to heat it so that I can remove as much of the block as possible
  2. can I simply turn the printer off and on again or will this damage the printcore since the printer wants me to remove it?
  3. Hi there, I realized after going through the remove PrintCore commands that excess dried filament was preventing the removal of the PrintCore . I think heating the PrintCore would be a potential solution but the screen is stuck on "Please remove the PrintCore from the print head slot 2". Is there any way for me to cancel this command to try heating it to clear the filament?
×
×
  • Create New...