UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
how can i able to print a model partially in cura ? Is it possible to cut the model in cura and able to print the balance of it. Below i attached the photos of my model. The figure 3.PNG is the model which i need to make changes. The fig 2.PNG is adjusted with the help of z offset. So using the z offset adjustment i can able to print top/bottom parts of the model. To check the right sizes of holes, i dont need to print the entire model. So is there is any method in cura to print the fig 1.PNG model, only the centre part of the model wihch is inside red marking?
Partially printing a model in cura
in UltiMaker Cura
Posted · Edited by albinv06
picture modifications
Hello,
how can i able to print a model partially in cura ? Is it possible to cut the model in cura and able to print the balance of it. Below i attached the photos of my model. The figure 3.PNG is the model which i need to make changes. The fig 2.PNG is adjusted with the help of z offset. So using the z offset adjustment i can able to print top/bottom parts of the model. To check the right sizes of holes, i dont need to print the entire model. So is there is any method in cura to print the fig 1.PNG model, only the centre part of the model wihch is inside red marking?
Regards