Lately, when I print, about 1 in 3 prints fails before it starts. I get the error: "nozzle offset probe failed please check the nozzles and bed and try again.". Once this occurs, it will fail with the same error every time.
I've tried:
-Turning the printer off and on.
-Update Cura.
-Update the Firmware.
-Grease and Lube.
Calibrated the B nozzle lift arm.
-Cleaned the plate.
-Manual leveling (works, for another print or two).
-Lower the plate, closer to it's bracket.
I've tried this proposed fix:
Manual leveling seems to be the only thing that pushes me through this, and gets "the next" print working, but it will inevitably fail again in just a couple of prints, back to square one.
I've thought of disabling active leveling altogether. I see that you can not do this on an S5, I'm not sure about my 3Extended.
I don't really use the second print head, I wish I could take that out of the equation.
Any advice, appreciated.