Jump to content
Ultimaker Community of 3D Printing Experts


New member
  • Content Count

  • Joined

  • Last visited

Everything posted by Snowfox222

  1. im running a davinci pro 3in1, and yes i know thats my first problem. ive been running cura for a few months now and have had little to no problems until this. last week i clogged my nozzle to the point of needing to disassemble my entire hotend three times in one day. on closer inspection i noticed that instead of my usual 6.5mm retraction, it was pulling the filament out of the hotend and partially into the bowden tube before running it back in again. no bueno. i tried adjusting my retraction to 6mm on the off chance the decimal place wasnt registering, but to no avail. i also tried just t
  • Create New...