Jump to content
Ultimaker Community of 3D Printing Experts


New member
  • Content Count

  • Joined

  • Last visited

Everything posted by bernd1000

  1. my print size is OK. use the JG Aurora A5 community firmware. But the Brim width is set to 150% (thin like a needle). and all flowrates to 140% to get a proper result. and please tell the community that the initial layer height must be, leveling distance + initial layer height = layerheight. its simply wrong that increasing this value increases adhäsion to the bed. when u choose initial layer height of i.e. 0.25 your true value is 0.25 +0.2 leveling distance. if u increase that 0.4 u`ll get only maggots on the bed.the extruder is hovering 0.6mm over the bed. better reduce to 0.1 for better a
  • Create New...