UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I just came here to say this is the correct answer for anyone looking for solution for seam alignment at overhangs. In Cura 4.9.0 the parameter is under Experimental tab and is called Overhanging Wall Angle with default value set to 90°.
90°:
20°: