Hey all! Hope I’m posting in the right area. Iv been dialing in my new printer and ran into an annoying issue. My e steps are calibrated and I’ve done a flow test with the hollow test cube with a single .48 wall. The flow test prints are great, I average the 4 walls and get around .5 to .51 which is close enough for me. Now when I print a normal cube as a final test I get gaps in the top infill layer and gaps between the inner and outer walls. If I bump up the flow in increments I can fix the gaps but then that defeats my flow test calibration settings and my top layer looks over extruded. Any tips ? Printer - creality cr6se -nozzle .4 , running latest version of Cura.